Function:

36 steps light controlling, can control light power on one step by one;

With two motion sensor, the stair light will power on from downstairs to upstairs when you go up, or from upstairs to downstairs when you go down;

Up to 800 pixels addressable light control, can control RGB water flowing light go with steps light at the same time.

Power:

Single color strip light for stair light,

When you use DC5V light, total power <350W，

When you use DC12V light, total power <700w,

When you use DC24V light, total power <1400w;

Water flowing light,

Total pixel <800 pixels,

*water flowing light is powered by separated power supply, it will not cost the power of controller.

Buttons and setting:

There is 4 button and 1 digital tube screen,

When power on and standby, it will display **-L, ** is the running speed of water flowing light, you can press SPEED+ & SPEED- to adjust.

1.Press SET, display L****,

*** is the pixel of water flowing light, press SPEED+ & SPEED- to adjust, it can be set 800 max., if you use 60 LEDs (20 IC) light, it can control 40m;

2.Press SET again, display LP**,

** is the color of water flowing light, press SPEED+ & SPEED- to change,

1=white, 2=red, 3=green, 4=blue, 5=yellow, 6=purple, 7=cyan, 8=auto change.

3.Press SET again, display LH**,

** is the running speed of water flowing light, press SPEED+ & SPEED- to adjust, number bigger, speed slower;

4.Press SET again, display F***,

*** is the quantity of steps, press SPEED+ & SPEED- to adjust,

5.Press SET again, display FP**,

It is the mode of stair light running, there is only one yet, it can not be adjusted.

6.Press SER again, display FH**,

** is the running speed of stair light, press SPEED+ & SPEED- to adjust, number bigger, speed slower;

7.Press SET again, display E***,

*** is the delay time after all lighting light up, press SPEED+ & SPEED- to adjust, number bigger, time longer, when it is 99, about 47s.

8.Press SET again, display **-L,

It is standby status, it will auto store the setting before at this moment, when controller power on again, it will still keep this setting.

Note:

if you want to set the stair light and water flowing light reach the end at the same time, please refer to this:

Pixel of water flowing light * Speed of water flowing light = steps * stair light SPEED